Reading (X) And Resetting (Z) Of Sales Totals; Summary Of Reading (X) And Resetting (Z) Reports - Sharp XE-A212 Manual De Instrucciones

A212_4 FOR THE MANAGER
READING (X) AND RESETTING (Z)
OF SALES TOTALS
• Use the reading function (X) when you need to take a reading of sales information entered since the last reset.
You can take this reading any number of times. It does not affect the register's memory.
• Use the resetting function (Z) when you need to clear the register's memory. Resetting prints all sales
information and clears the entire memory except for the GT1 through GT3, Training GT, BAL, reset count, and
consecutive number.

Summary of Reading (X) and Resetting (Z) Reports

1
X1 and Z1 reports: Daily sales reports
X2 and Z2 reports: Periodic (monthly) consolidation reports
When you take an X or Z report, turn the mode switch to the appropriate position referring to the column of
"Mode switch position" shown on the table below, and use the following corresponding key sequence.
Mode switch position
Item
OPX/Z
Flash report:
(Only display)
To clear the
display, press the
l
key or turn the
mode switch to
another position.
Full sales report
PLU report by
designated range
Individual clerk
report
X, Z
Full clerk report
Hourly report
Open GLU report
Open GLU report
by clerk
Balance report
64
03.7.5 8:03 AM Page 64
X1/Z1 X2/Z2
Dept. code
X -- --
@
key: Amount of cash in drawer
A
key: Sales total
--
X1, Z1 X2, Z2 Reading:
Reading:
--
--
X1, Z1
Resetting:
Reading:
-- --
(The report of the current clerk)
--
X1, Z1 -- Reading:
-- X1, Z1 -- Reading:
-- -- Reading:
X1, Z1
-- X1, Z1 Reading:
--
(The report of the current clerk)
-- X1
-- Reading:
Key operation
d
: Department sales total
!
For dept. 1 to 6: Dept. key (
A
Resetting:
All PLUs
Start
@
PLU code
All PLUs
Start End
@
PLU code PLU code
L
Resetting:
L
Resetting:
s
Resetting:
G
Resetting:
c
Resetting:
r
(
to )
P A
End
p
PLU code
P p
L
P
L
P
s
P
G
P
c
P