Guidance For Text Programming - Sharp XE-A212 Manual De Instrucciones

A212_3 FOR THE MANAGER

Guidance for text programming

The register allows you to program text for clerk names, department item names, PLU/subdepartment item
names, if necessary. When you program texts, place the keyboard sheet for text programming over the
keyboard sheet for ordinal use. For the placement, please refer to "Keyboard sheet" section on page 6.
There are two ways for programming text; using character keys (shaded area shown below on the keyboard
sheet for text programming) or entering character codes with numeric keys on the keyboard.
Keyboard sheet for text programming
Please note that the character keys used for entering numbers (shaded area) are different from numeric keys.
The following are used as control keys for text programming.
H
Toggles between upper-case and lower-case letters. By default, the upper-case letter is selected. Once
H
the key is pressed, you are locked in for entering lower-case letters. "a" is displayed when lower-case
letters entry is selected as shown in the operator display example below.
W
Toggles between single-size and double-size characters. By default, the single-size character is selected.
W
Once the key is pressed, you are locked in for entering double size characters. "W" is displayed when
double-size characters entry is selected as shown in the operator display example below.
B
Backs up the cursor, erasing the character to the left.
Using character keys (Keys on the shaded area)
To enter numerals, letters and symbols, simply press the corresponding character on the shaded area on the
keyboard.
Operator display (Example)
03.7.5 8:02 AM Page 31
Cursor
ABCD
01 Wa
Department code, PLU code, function number,
clerk code or logo message line number is displayed here.
Characters entered using character keys is displayed here.
PGM
04
Number of characters programmed
31