Ej Report Reading And Resetting; Printing Journal Data On The Way Of A Transaction; Reading And Resetting The Electronic Journal Data (Issuing Ej Report) - Sharp XE-A212 Manual De Instrucciones

A212_4 FOR THE MANAGER

EJ REPORT READING AND RESETTING

The cash register provides an electronic journal (EJ) function. This function is intended to record the journal
data in a memory instead of journal paper, and print the data as an EJ report. The register records the journal
data in REG, PGM,
memory. For details of EJ programming, please refer to "Other programming (Job code 68)" on page 54 and
"EJ memory type" on page 57.

Printing journal data on the way of a transaction

You can print journal data of a current transaction recorded in EJ memory by pressing the
transaction.
This function is valid when the printing style is programmed to receipt, and the receipt ON/OFF
function is set to OFF.
• Sample print

Reading and resetting the electronic journal data (Issuing EJ report)

You can read the journal data stored in the EJ memory in the journal format by executing the following
procedure in the X1/Z1 or OP X/Z mode.
To read all of the data:
@
700
To reset all of the data:
P
700
To read the last 10 records:
@
710
• To stop reading or resetting the data, turn the mode switch to
"MGR" position. The data will not be erased when resetting.
• On the EJ memory, a maximum of 9000 (or 8000, depending
on programming) lines of data can be stored. When executing
all data reading, all of the data stored in the EJ memory will be
printed.
• When printing is performed continuously, the printing may be
intermitted several seconds. After the intermission, the printing
will be restarted.
68
03.7.5 8:03 AM Page 68
, X1/Z1 and X2/Z2 modes. By default, a maximum of 9000 lines are stored in the
EJ report title
EJ report end title
A
@ A
A
R
• Sample EJ report
key during the
Header
information
print