Observing Ambient Temperature And Ventilation; Connecting The Appliance - Bosch 8 Serie Instrucciones De Uso

en
Observing ambient
temperature and
ventilation
The climate class can be found on the
rating plate. It states the room
temperature within which the appliance
can be operated.
Climate class
SN
N
ST
T
Ventilation
Fig. 3
The air on the rear panel of the appliance
heats up. Conduction of the heated air
must not be obstructed. Otherwise, the
refrigerating unit must work harder.
This increases power consumption.
Therefore: Never cover or block ventilation
openings!
We recommend a distance of 70 mm
from the back wall.
28
Permitted ambient
temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior of the
appliance.
See Cleaning the appliance" section.
The socket should be freely accessible.
Connect the appliance to 220-240 V/
50 Hz alternating current via a correctly
installed earthed socket. The socket must
be fused with a 10 to 16 A fuse.
If the appliance is to be operated in
a non European country, check on the
rating plate whether the indicated voltage
and current type correspond to the values
of your mains supply. The rating plate is
situated in the bottom left hand side
of the appliance. The power cord may
be replaced by a technician only.
Warning
!
Never connect the appliance to electronic
energy saver plugs or to power inverters
which convert the direct current to 230 V
alternating current (e.g. solar equipment,
power supplies on ships).