Inspection-Description Of The Machine; Handling - Transport - Husqvarna TS 100R Manual De Usuario

Instruction plate
1
2
3
4
5
1. Type 2. Weigth
4. Bore 5. Speed
7. Fabrication year 8. Power
10. Frequency 11. Intensity
Use
Sawing marble, stone, granite, brick, cement and all fac-
ings (porcelain, glazed tiles, ceramics, etc).
Tools
Water lubricated diamond disc diameter
300 mm - diameter 350xmm (D) - bore 25.4
mm (AL). (Information from your usual sup-
plier).
1
1. Carborundum disc
Any application not corresponding with the intended use
(use of a saw blade, abrasive disc, etc) is prohibited.
Inspection-Description of the
machine
• On receiving the machine check its condition.To
unscrew the screws K using key 7, and to mount the
handles (see fig 7)
• Always keep it perfectly clean.
• Check the supply cable and the extension lead periodi-
cally
• Always keep alert when working.
• Check that the parts are properly fixed (no abnormal
vibration) and that it is correctly assembled.
Operator's manual - TS 100 R
6
7
8
9
10
11
3. Maxi tool
6. Serial
9. Voltage
T
AL
D
2
2. Saw blade
See fig. 1a-1b
1. Chassis-tank
2. Leg
3. Leg locking knob
4. Water pump
5. Head locking knob
6. 90° to 45° locking knob
7. 30 mm spanner
8. Drain plug
9. Motor
10. Lack of voltage switch
11. Operating handle
12. Disc casing
12b. Removable guard
13. Rail
14a. Large table
14b. Small table
15. Plate stops
16. Cutting head
17. Carriage
18. Manufacturer's plate
19. 90° cutting guide
20. Plate side extension
21. Wheel for tightening the extension
22. Transport handles
23. Wheel for fixing the disc guard
24. Height adjustment plate
25. Height adjustment tightening knob
26. Cutting depth adjustment screw
27. Table tilting safety latch

Handling - transport

Lock the moving head on the front part of the rail using
the knob (5).
Hold the machine by the handles (22)
Fitting the legs :
• Loosen the four flywheels (3).
• Bring two of the feet to the front (check the angle of
the feet connectors).
• Lift the front and lower the feet into the supports.
• Proceed in the same way for the back.
• Immobilize the flywheels (3).
For these different operations always dis-
connect the machine!
15
English -