Oven Lifting; Assembling Of The Components - OEM MILLENNIUM MM Manual De Uso

MILLENNIUM MM/MB
Installation and connections
Chapter 3
All operations described in this chapter shall be
carried out by skilled and authorized technicians,
only.
3.1 - OVEN LIFTING (Fig 1)
The oven lifting shall be carried out by using a crane or
a tackle as follows:
• The oven shall slightly alternatively be lifted from its
four sides using a lever and making sure the panels
are not damaged, then the oven shall be positioned
on shims (1).
• insert two belts (2) being properly dimensioned
according to the weight of the oven, under the base
(3) of the latter and connect them with a hook (4) of a
crane or a tackle.
ATTENTION
To hoist the machine do not use steel belts as they
may damage the outside body.

3.2 - ASSEMBLING OF THE COMPONENTS

Regarding the assembling of the support, the hood
and the relevant components, please follow the
instructions in the relevant handbooks.
• Position the support (1) near the final oven installation
area by positioning its possible braking wheels (op-
tional) onto the front side.
Brake the front wheels by the lever (2) or level the
oven by operating its adjustable feet (3) depending
on the kind of support.
Single-chamber oven assembling (Fig 2)
• The oven (4) shall be lifted as indicated in "lifting"
paragraph and positioned on the base.
• Fix the oven (4) to the support (1) by the screws (5)
and the washers supplied with the support set.
DANGER
IMPORTANT
FIG. 1
2
1
3
FIG. 2
4
5
3
4
2
1
1
2
GB - 11
1