Angle Adjustment; Recommended Chain Speed - Husqvarna WSC 40 Manual De Instrucciones

Angle adjustment

Angle adjustment is used to get a perfect cut in angles
close to ceiling, wall or floor. Adjust the angle to its
maximum position. The direction is depending on the cut.
Loosen the screw and adjust the angle.
WARNING! Always tighten the screw with
!
tightening torque 20 Nm (15 ft-lbs).

Recommended chain speed

For best cutting performance, use full cutting speed 28 m/
s (92 ft/s) in soft and medium concrete.
If WS 482 is used, make sure that mechanical gear 2 is
engaged to get correct display of chain speed.
CAUTION! Cutting at too low revs can cause damages
to the chain and chain bar. Check that the correct
mechanical gear is selected! A lower chain speed
should be used when cutting in hard concrete than if
cutting in soft concrete.
16 – English
OPERATING