General; Maintenance Schedule; Cleaning; External Cleaning - Husqvarna WSC 40 Manual De Instrucciones

General

WARNING! The user must only carry out the maintenance and service work described in this
!
manual. More extensive work must be carried out by an authorized service workshop.
Inspection and/or maintenance should be carried out with the motor switched off and the power
plug disconnected.
Wear personal protective equipment. See instructions under the heading "Personal protective
equipment".
The life span of the machine can be reduced and the risk of accidents can increase if machine
maintenance is not carried out correctly and if service and/or repairs are not carried out
professionally. If you need further information please contact your nearest servicing dealer.
Let your Husqvarna dealer regularly check the machine and make essential adjustments and repairs.
Always perform maintenance and service in a tidy environment without debris on the floor.

Maintenance schedule

In the maintenance schedule you can see which parts of your machine that require maintenance, and with which
intervals it should take place. The intervals are calculated based on daily use of the machine, and may differ depending
on the rate of usage.

Cleaning

Greasing
Functional inspection
Cleaning

External cleaning

The wall saw chain attachment should be cleaned once the cutting is finished. Use the cleaning brush that is supplied
with the wall saw and connect it to the water hose. Clean all equipment in the system.
WARNING! Do not use high-pressure washers to clean the machine.
!
18 – English

MAINTENANCE

Daily Maintenance
External cleaning
Spray chain and guide bar with oil.
Grease the guide bar. Stroke in the
lubrication point until the chain bar is
filled with grease.
General inspection
Water system
Cover and spray guard
Guide bar, diamond chain and drive
sprocket
For each square meter of sawing
Grease the guide bar with 2-3 strokes
in the lubrication point