Husqvarna WSC 40 Manual De Instrucciones página 9

3 Make sure that the surfaces on the machine and on
the saw head are clean.
4 Use both hands to lift up the machine in the parallel
handle from the storage box.
5 Slide the WSC 40 onto the wall saw arm. Push on the
hexagon shaft while moving the unit carefully around
the center to align the shaft. The shaft should now be
in it's intermediate locked position, Check by pulling
ASSEMBLING AND ADJUSTMENTS
the wall saw chain attachment. Make sure that the
machine is locked on the saw arm.
6 Fold over the clamp that locks the attachment to the
handle bar. Tighten the locking knob.
7 Tighten the machine to the saw head with the bolt in
the spindle hub. Put one hand on the chain for
resistance. Don't forget to wear gloves. Use the 18
mm wrench provided in the tool box. Use the
tightening torque 70-80 Nm (52-59 ft-lbs).
–
English 9