Hand Piece; T Ools; W Orking Instructions; S Ervice / M Aintenance - SUHNER ABRASIVE SP 700 Hook Documentación Técnica

3.
handlIng
3.1

hAnd Piece

manufacturer must be observed! Use only hand pieces in
perfect condition. Examine hand piece before use. The
hand piece must be centred and secured with the lock-
nut.
V
ery shArP BlAde
3.1.1 c /c
hAnging onnecting the hAnd Piece
Screw the hand piece to pneumatic drive, align it, and se-
cure with locknut. After connecting, press the grease can
button two to three times. If you cannot completely screw
in the hand piece, turn the blade slightly.
V
ery shArP BlAde
3.2 t
ools
Use only clean tools!
3.2.1 c /
onnecting detAching
Use an allen key to loosen the setscrews.
/ o
PeratIon
Only SUHNER hand piec-
es must be used. The in-
structions issued by the
!
!
/
the BlAde
Remove the blade housing by drawing it towards you.
Detach the blade from the blade housing. To connect
the blade, follow the above instructions in reverse order.
Tighten the screws with max. 1.5 Nm. After connecting,
press the grease cup button two to three times.
V
ery shArP BlAde
3.3 w
orKing instructions
Machine still runs out when the valve lever
is released! On compressed air failure the
valve lever must be released!
4. s
ervIce
4.1 P
reVentiVe mAintenAnce
The machine must be cleaned
daily. When cleaning, examine all
parts for wear, fracture, cracking,
or other signs of damage. Without a tool clamped in
check no-load speed periodically and after each mainte-
nance. Even if the machine still operates perfectly, the
motor should be removed, cleaned and the four slides
checked for wear by a specialist after approx. 300 to 400
operating hours.
V
ery shArP BlAde
!
/ m
aIntenance
!
21