After Use - Remington IPL6000 Guía De Uso Y Cuidado

7. Try to treat in an organized, grid-like
pattern to ensure you cover all the
hairs in the intended treatment area.
Repeat step 6 until the desired treat-
ment area is fully covered. Depending
on the body part, the treatment time
will vary.

after use

• When your session has been com-
pleted turn off the system by turning
the POWER SWITCH off. (Be sure to
remember the last energy level setting
you used as it will not be restored when
turning the system on again).
• Unplug the power cord from the
electrical outlet.
DO NOT flash on the same treatment
spot multiple times during the same ses-
sion, as this could cause skin swelling,
temporary blisters or could change the
color of your skin.
Note: For faster coverage, hold down
the FLASH BUTTON while you lift the
HANDPIECE and place it back in contact
with the new area to be treated. After
about 2 seconds, the unit will deliver a
flash to the skin as soon as full contact
between the skin and the HAND PIECE is
established.
• After each hair removal session it is
recommended that you clean your
system, especially the NOSE CONE and
FLASH WINDOW (See "Cleaning"
page 32)
• After cleaning, we recommend that you
store your i-Light Pro system in its origi-
nal box and keep it away from water.
31