To Stop The Product; To Replace The Diamond Tools - Husqvarna PG 510 Manual Del Usuario

To stop the product

CAUTION Do not lift the tool plate from the
surface when you stop the motor. The tool
plate rotates for a while after the motor
stops. Much off the dust can blow off in to
the air and the surface can be damaged.
CAUTION If you grind adhesive asphalt,
paint or equivalent material, lift up the front
of the product slightly when the tool plate
stops. The product can attach to the
adhesive surface if not lifted.
1. Turn the ON/OFF switch to 0 to stop the motor.
2. Keep the tool plate against the surface. Make sure
that the tool plate does not rotate before you lift up
the front.
3. Pull out the power plug.

To replace the diamond tools

WARNING Disconnect the power plug.
WARNING Use protective gloves, as
diamond tools can become very hot.
1. Turn the ON/OFF switch to 0 and disconnect the
power plug to stop the product.
12
2. Push the emergency stop.
3. Put the product into servicing position.
4. Use a hammer to remove the diamond tools.
1146 - 001 - 29.04.2019