To Adjust The Frame Height; Diamond Tools - Husqvarna PG 510 Manual Del Usuario

3. When the handle position is set, pull the handle lock
knobs up (A) and put them into idle position (B).
A
B

To adjust the frame height

The angle of the frame can be changed to divide the
weight of the chassis. This is to decrease or increase
the grinding pressure against the surface.
Adjust the angle to set up a good work position for
different operators.
1. Remove the lock knobs (A) to loosen the support
foot (B).
A
B
1146 - 001 - 29.04.2019
2. Hold the handlebar to keep the frame stable and lift
A
B
3. Select the applicable position for the operation and
Handle heights
Hole position
Top
Center
Lower

Diamond tools

There are many types of diamond tools for the product.
Speak to your approved service center or go to
www.husqvarnacp.com to select correct diamond tool.
Installation of the diamond tools
The installation of the diamond tools on the tool plate
has effect on the performance of the product. The
the support foot out and up.
tighten the lock knob. The bottom hole increases the
grinding pressure and the height of the handlebar.
The top hole decreases the grinding pressure and
the handlebar.
Handle height, mm
765
870
960
9