Setup 4; Unpacking And Checking Accessories; Setting Up And Connecting; Pre-Heating - DENTSPLY Multimat Easy Manual De Instrucciones

‹ Unpacking and checking accessories

1. Check the Shockwatch sticker on the cardboard box.
If the sticker has turned red, the impact energy
during transport was higher than allowed, and your unit
could be damaged. Ask the transport agent to
confirm the triggering of the Shockwatch label in writing.
2. Open the cardboard case and remove the upper foam
shell.
3. Remove the unit including its accessories.
4. Check whether the scope of delivery is complete (see
"Scope of delivery") or damaged in transit. Notify
DeguDent GmbH immediately of any damage.

‹ Setting up and connecting

1. Place the device on a sturdy, non-flammable surface.
The minimum distance from the nearest wall or
object is 25 to 30 cm (see also "Safe operation").
2. Connect the device end of the mains cable to the unit.
Connect the mains plug of the mains cable to a
properly installed and protected mains socket (see
"Technical specifications and operating environment").
The Multimat Easy must be the only device on its cir-
®
cuit. No extension cords may be used.
3. Connect the tubing between the vacuum pump
(available separately) and the air inlet that the device
(see illustration).
4. Place the firing base on the firing lift; use the magnetic
firing platform where appropriate.

‹ Pre-heating

Before operating the Multimat
after prolonged periods of non-use, it is recommended
to pre-heat the unit once. To do so, choose a special pre-
heating program from among the pre-defined programs
(see "Menu explanations"). For instructions on starting
a program, see "Turning on the unit/Starting a firing pro-
gram".
Easy for the first time or
®

Setup 4

45
MultimatEasy