Troubleshooting; Technical Specifications - Saeco LAVAZZA MIO RI9575/31 Instrucciones Para El Uso

Problems
The machine does not turn on.
: power light is off after having
EXTRA
turned the machine ON and waited for a few
minutes.
: the brew lights and are not
PREMIUM
blinking.
The machine requires a lot of time to heat up.
The pump is very noisy.
The loading lever doesn't reach the brewing
position.
The coffee is cold.
The coffee is brewed too fast, the brewed
coffee is not creamy.
The coffee is not brewed and some steam comes out
from the pod compartment.
Coffee is not brewed or brewed in drips only.
The pods, after they have been used, have
holes only on the upper film.
Hot water/steam not dispensed.
The milk does not froth.
Please contact a Saeco authorized service center for any faults not covered in the above table or when the suggested solutions

TECHNICAL SPECIFICATIONS

· Nominal Voltage - Power Rating - Power Supply: See label on
the appliance
· Dimensions:
Height Width
12" (305 mm) 9.25" (235 mm)
· Weight: about 11 lbs. (5 kg)
· Water tank: 34 oz. (1 lt.) - Removable type
· Housing Material: ABS - Thermoplastic

TROUBLESHOOTING

Causes
» The machine is not connected to the
power source.
» The machine has limescale build-up.
» No water in the tank.
» Circuit is not primed.
» Dregdrawer full.
» Pod inserted incorrectly.
» : the brew light was off when
EXTRA
the brew button was pressed.
» Pod already used.
» The loading lever was not set to the
brewing position.
» Dispensing spout is clogged.
» Circuit is not primed.
» Circuit is not primed.
» Hot water/steam wand is clogged.
» Not suitable milk.
» The milk is too hot.
» : the steam light was off when
EXTRA
the steam was dispensed.
do not solve the problem.
· Power Cord Length: 47" (1.2 m)
· Control Panel: Top of machine
· Boiler: Stainless steel
Depth · Safety Devices: Boiler pressure safety valve
13" (330 mm) · Thermal fuse (EXTRA and PREMIUM versions)
· Safety thermostat (PREMIUM version)
2006/42 CE - 2004/108 CE - 2006/95 CE
Solutions
» Connect the machine to the power source.
» Contact Saeco customer service.
» Descale the machine.
» The tank with fresh drinking water.
» Prime the water circuit.
» Empty out the dregdrawer.
» Repeat the sequence, lever in the off position,
lever in the brewing position; if that is not enough
remove the pod manually from the compartment
after unplugging the machine.
» Wait until the indicator light turns on.
» Place the lever back in the off position and insert
a new pod.
» Set the loading lever to the brewing position.
» Clean the dispensing spout.
» Prime the water circuit.
» Prime the water circuit.
» Clean the wand with a needle (the machine needs
to be unplugged and the steam/hot water knob
needs to be closed).
» Use fresh, partially skimmed milk.
» Use milk at refrigerator temperature.
» : press the witch and wait until the
EXTRA
indicator light turns on.
EN