Turning On The Lights; Maintenance; Safety Rules; Cleaning The Machine - Bezzera BZ16 Manual De Instrucciones

the section of the hydraulic circuit PUMP-GAUGE
(S version).

5.9 Turning on the lights

BZ16 espresso coffee maker is equipped with a
front illumination device. To activate illumination,
press the switch (Fig. 01; pos. 19) located under-
neath the machine.

6 - MAINTENANCE

To allow the machine to work correctly, follow the
maintenance instructions provided below.

6.1 Safety rules

Do not subject the machine to water jets. Discon-
nect the machine from the electrical power by turn-
ing the electrical power network omnipolar knife-
switch lever to the resting position 0. Remove the
plug and close the water interception tap before
carrying out maintenance and/or cleaning work.
If the machine is malfunctioning, do not attempt
to repair it alone and call the technical assistance
service immediately. If the electrical power cable
has been damaged, turn off the machine immedi-
ately, turn off the water and call the technical as-
sistance service. Do not replace it alone. Carry out
cleaning/maintenance when the machine is cold,
preferably wearing protective gloves.

6.2 Cleaning the machine

Warnings: For the best results and in
compliance with current regulations,
change the water contained in the
boiler and pipings at every daily startup
of the machine.
These advices are indicative, the maintenance and
cleaning schedules depend on the use of the ma-
chine.
After each use
1) Clean the steam nozzle.
2) Clean the filter holder and the filters.
Daily
1) Clean the cup holding grid and the drain ba-
sin.
2) Clean the body.
3) Clean the group's gasket with the brush sup-
plied.
4) Wash the group as follows: hook the filter hold-
er with the blind filter supplied to the group and
initiate output for a few times.
5) Immerse the filter holder and the filters in hot
water for a few minutes to dissolve the grease
of the coffee, use a cloth or sponge to remove
it.
For washing and cleaning operations,
do not use solvents, detergents or abra-
sive sponges but only specific products
for coffee machines. Wash the body us-
ing a cloth soaked in water and/or neutral deter-
gents, and dry the surfaces well prior to connect
the machine to the electric line again. Use water to
wash the cup holding grid and the drain basin.
Use water and neutral detergents to clean the tank
after removing it. When finished rinse thoroughly.
Replace the tank and insert the silicon tube.
6.3 Safety thermostat - Manual re-
arming
Warning! The operation de-
scribed below is only relevant to
an installing technician who is
authorised by the manufactur-
er.
While the machine is working, the boiler resistance
may overheat and, cutting off power, sets off the
safety thermostat that prevents any further damage
to the boiler. To restore normal operations, resolve
the malfunction that triggered the safety thermostat
and restore normal conditions by pressing the red
button (RESET) (Fig. 08).

6.4 Correct product disposal

(electrical and electronic waste)
(Applicable in the European Union countries and
those countries with separate waste collection sys-
tems).
The sign carried on the product or on its
documentation indicates that the prod-
uct must not be disposed of with other
domestic waste at the end of its life cy-
cle. To avoid any damage to the environment or to
health, caused by unsuitable waste disposal, the
user is asked to separate this product from other
types of waste and to recycle it responsibly to help
the sustainable recycling of material resources.
31
BEZZERA BZ16
MOD.