Pioneer X-SMC5-K Manual De Instrucciones página 47

Additional information
When connected to an HDMI-compatible device
Problem
Picture is not displayed.
Sound is not produced or is
distorted.
Multichannel audio signals
are not output.
Colors are not properly
displayed on TV screen.
Network
Problem
Cannot access to the
network.
Cannot access to the network
using WPS.
Cannot access to the
component or PC connected
via network.
Playback does not start.
The PC or Internet radio is
not properly operated.
Check
Is the resolution properly set?
Is the HDMI cable properly
connected?
Is HDMI Out properly set?
Is HDMI Out properly set?
Is HDMI Color properly set?
Check
The LAN cable is not firmly
connected.
The router is not switched on.
Network Type is set to Wired.
Internet security software is currently
installed in the connected
component.
The audio component on the network
which has been switched off is
switched on.
The component connected to the
network is not properly set.
There are no playable audio files on
the component connected to the
network.
The component is currently
disconnected from this unit or the
power supply.
The corresponding IP address is not
properly set.
The IP address is being automatically
configured.
Remedy
Set HDMI Resolution properly for the connected device (page 34).
Restore HDMI Resolution to the default setting (720x480p/
720x576p) (page 34).
Try disconnecting the HDMI cable, then securely reconnecting it.
With some cables, 1080p video signals will not be output.
Set HDMI Out to LPCM (2CH) or Auto (page 34).
The HDMI Out terminal does not output any audio signals except
DVD/CD sound.
Set HDMI Out to Auto (page 34).
The HDMI Out terminal does not output any audio signals except
DVD/CD sound.
Change the HDMI Color setting (page 34).
Remedy
Firmly connect the LAN cable (page 9).
Switch on the router.
Network Type must be set to Wireless or Auto to use WPS
connection. See page 31 to change the network type.
There are cases where a component with Internet security software
installed cannot be accessed.
Switch on the audio component on the network before switching on
this unit.
If the client is automatically authorized, you need to enter the
corresponding information again. Check whether the connection
status is set to "Do not authorize".
Check the audio files stored on the component connected to the
network.
Check whether the component is properly connected to this unit or
the power supply.
Switch on the built-in DHCP server function of your router, or set up
the network manually according to your network environment
(page 36).
The automatic configuration process takes time. Please wait.
15
47
En