Astralpool PRO ELYO INVERBOOST NN Serie Manual Del Usuario página 35

6.7 Installation of the display deportee
Photo(1)
- The end with plug connects with the control panel (photo1)
- The other end of the signal wire. (photo2)
- Open the cover of the terminal box and pass through it the cable of the remote screen.(photo3,4)
- Insert the wiring into the designated position on the Modbus Module or PCB(without Modbus). (photo5)
6.8 Installation of the Modbus/Fluidra Connect Signal Wire
Photo(6)
- Open the cover of the terminal box (photo6)
- Take the Modbus/Fluidra Connect signal wire from the accessories
wire into the signal wire from Modbus/Fluidra Connect Module. (photo 8)
- Three wire terminal :"A+" ,"B- ", "GND" (Photo 9)
ATTENTION :
Disconnect: A means to disconnect should be located within sight of and readily accessible from the
unit(circuit breaker, fused or un-fused switch). This is common practice on commercial and
residential heat pumps. It prevents remotely-energizing unattended equipment and permits turning
off power at the unit while the unit is being serviced.
6. 6. 6. Electrical Electrical Electrical
Photo(2) Photo(3)
Photo(7)
Wiring Wiring Wiring
Photo(4)
Photo(8)
( ) and
photo7
- 31 -
Photo(5)
Photo(9)
put the round end of the signal