Electrical Connection - Astralpool PRO ELYO INVERBOOST NN Serie Manual Del Usuario

6.6 Electrical connection

The power supply for the heat pump must come, preferably, from an exclusive circuit with regulatory protection
components (30mA differential protection) and a magneto-thermal switch.
- The electrical installation must be carried out by a specialized professional (electrician) in accordance with the
standards and regulations in force in the country of installation.
- The heat pump circuit must be connected to a safety earth circuit at the terminal block.
- The cables must be properly installed to prevent interference.
- The pump is intended for connection to a general power supply with earth connection.
- Section of the cable; This section is indicative and should be checked and adapted according to the needs and
conditions of use.
- The tolerance of acceptable voltage variation is +/- 10% during operation.
The connections must be dimensioned according to the power of the device and the state of installation.
Models
PROELYXP07i
PROELYXP09i
PROELYXP11i
PROELYXP14i
PROELYXP16i
PROELYXP20i
PROELYXP26i
PROELYXP30i
PRO ELYO INVERBOOST NN 26T
PRO ELYO INVERBOOST NN 35
PRO ELYO INVERBOOST NN 35T
These values are given as a guideline, only an authorized electrician can determine the values
corresponding to your installation.
The electric cable must be equipped with a ground connection and with a circuit breaker with
30mA.
differential
6. 6. 6. Electrical Electrical Electrical
Circuit breaker
2,5 mm²
7 A 84 m
9 A
57 m
11A
14 A 43 m
16 A 34 m
20 A 29 m
26 A /
35 A /
9 A 15 m
34 A /
13 A 12 m
- 30 -
Wiring Wiring Wiring
Maximum length of the wire
4 mm²
135 m
90 m
68 m
54 m
45 m
25 m
/
35 m
/
27 m
6 mm² 10 mm²
200 m 335 m
130 m 225 m
100 m 170 m
80 m 135 m
66 m 110 m
38 m 62 m
22 m 36 m
49 m 81 m
22 m 36 m
39 m 68 m