Astralpool PRO ELYO INVERBOOST NN Serie Manual Del Usuario página 38

Parameter checking:
Press first, then press
Code
d0 IPM mould temperature
d1 Inlet water temp.
d2 Outlet water temp.
d3 Ambient temp.
d4 Frequency limitation code
d5 Piping temp.
d6 Gas exhaust temperature
d7 Step of EEV
d8 Compressor running frequency
d9 Compressor current
d10 Current fan speed
d11 Error code for last time
d12 MOBUS COM
d13 MODBUS ID Address
d14 Product Code
Remark:
d4:Frequency limitation code,
0: No frequency limit;
2: Overheating or overcooling frequency limit; 4:Drive Current frequency limit;
8:Drive voltage frequency limit;
Press first, then press
Code Name
P0 Mandatory defrosting
P1 Working mode
P2 Timer on/off
P3 Water pump
P4 Current time
P5 Timer on
P6 Timer off
P7 Water temp. calibration
P12 MOBUS COM
P13 MODBUS ID Address
7. 7. 7. Start-up Start-up Start-up of of of
to check the User parameter from d0 to d14
Condition
1:Coil pipe temperature limit;
16:Drive high temperature frequency limit
to check/adjust the User parameter from P1 to P7
Scope Default
0-1 0
0-1 1
0-1 0
0-1 0
HH:MM 00：00
HH:MM 00：00
HH:MM 00：00
-9～9 0
0 - 5 0
1 - 88 9
the the the Heat Heat Heat Pump Pump Pump
Scope
0-120℃
-9℃～99℃
-9℃～99℃
-30℃～70℃
0,1,2,4,8,16
-30℃～70℃
0℃～C5℃ (125℃)
0～99
0～99Hz
0～30A
0-1200 (rpm)
All error code
0 - 5
1 - 88
0000- FFFF
0: Default normal operation
1: mandatory defrosting.
1:Heating mode, 0:cooling mode,
1 Timer on/off is under function， 0 Timer on/off is out
of function (The setting of P5 and P6 won't work)
1:Always running;
0:Depends on the running of compressor
0-23:0-59
0-23:0-59
0-23:0-59
Default setting: 0
Modbus Only（default value after reset）
Modbus Only（default value after reset）
- 34 -
Remark
Real testing value
Real testing value
Real testing value
flash if Real value<-9
Real testing value
flash if Real value<-9
Real testing value
N*5
Real testing value
Real testing value
Real testing value
Setting, Modbus Only
Setting, Modbus Only
Setting, Modbus Only
Remark