Sensor Control Panel (Fig.25); Clamps; Remote Control (Fig.22); Personal Computer - Corghi EXACT 70 Manual De Uso

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
F) Head orientation: assemble the head respecting
the car orientation shown on the data plate.

Sensor control panel (fig.25)

A) Sensor on/off key.
B) ROC key.
C) Special functions key.
D) Electronic levelling device LED, indicates when
the sensor is levelled.
E) Electronic levelling device LEDs, indicate when
the sensor is not levelled.
F) Sensor connection LED. when off, there is a
fault on the sensor, when it is on the sensor
is in operation but communications with the
central unit have failed, and when it is flashing
the sensor is in operation and communicating
with the central unit.
G) LED 1 on while ROC is in progress.
H) Sensor status LED. when always on, the sensor
is in operation; in radio versions, flashes to warn
that the battery charge is running out.
I) LED 2 on while ROC is in progress.
J) YELLOw LED: battery recharging under way
K) RED LED: error during battery recharging

Clamps

The clamps function in the same way as ordinary
self-centring clamps.
Use the handles (C fig.26) to fix the clamp to the
rim or remove it.
The release lever (A fig.26) can be used to lower
the sensor connection point to prevent particularly
low spoilers from interfering with the measure-
ments (fig.27).
To fix the sensor at the required height, tighten
the fixing screw (B fig.26) with the sensor in the
position of choice.
These clamps are also able to operate on cars with
wrap-around fenders (Citroen); in this case, mount
the clamps in the horizontal position.
On small-diameter rims, always perform compensa-
tion with the clamps in the horizontal position.

remote control (fig.22)

The Enter (N) and Esc (O) keys and the four arrows
(P) duplicate the functions of the same keys on the
keyboard and the central unit control panel.
It is powered by an ordinary 9V DC battery.
Operator's Manual EXACT 70
wait a few seconds to allow the monitor to switch on
and the computer to load the program.
The personal computer, and thus the entire wheel
aligner, can only be switched off using the command
provided in the wheel alignment program.
Switching off the personal computer without using
the command provided may damage the software
installation.
When the wheel aligner is switched off using the
software command, the PC, the monitor and the
printer switch to standby status. To switch off these
devices completely, use either the relative on and
off buttons, or the PC feeder switch (switch marked
C turned to 0), or cut off the wheel aligner power
supply at the mains.
Keep the original GHOST and aligner software CD-
ROMs for future system upgrades.
The software on the CD-ROM is the property of
Corghi S.p.A. and can be used only with the per-
sonal computer supplied with the equipment.
Commands and information for moving around the
vehicle wheel alignment program.
An icon is a key on the screen which performs a
specific action when it is selected. This function is
the same throughout the procedure.
The icon's function is identified by a graphic
symbol; a brief comment is also provided in the
feedback bar.
Move to the icons, using the keys ←, →, ↑, ↓ and
select them with ↵.
http://www.eichstaedt-elektonik.de

PErSoNAL ComPUTEr

IMPORTANT
IMPORTANT
IMPORTANT

oPErATor INTErFACE

Icons

EN
59