Remote Control; Maintenance - Corghi EXACT 70 Manual De Uso

CALIBrATIoN
Data on red background persist
with sensors fitted on calibrator,
connected correctly and levelled
Something is obstructing the passage of the infra-
red beam between the goniometers
➥ Remove the obstruction.
One or more transducers out of tolerance range
➥ Call the service centre and do not use the wheel
aligner.

rEmoTE CoNTroL

Program does not change when
keys are pressed
Battery flat
➥ Replace the battery.
Distance between remote control and central
unit too great
➥ Move closer: max distance 6m.
Remote control pointing in wrong direction
➥ Point the remote control towards the eye of the
receiver.
➥ Hold the remote control properly.
Too much ambient light
➥ Move closer.
PrINTEr
Does not switch on
Printer switch "OFF"
➥ Turn the printer switch to "ON".
No power
➥ Check that the printer plug is connected cor-
rectly.
Switches on but does not print
Cable crushed between steel plate parts
➥ Position the cable correctly.
Printer in standby status, "on line" LED off
➥ Press the "ON LINE" button to illuminate the
LED.
Does not print properly
Print head failure
➥ Call the service centre.
90
Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
http://www.eichstaedt-elektonik.de
Printing too pale
Ink ribbon worn out or broken
➥ Change the cartridge, following the instructions
in the printer manual.
"Error" LED on - "Error" LED
flashing
No paper
➥ Fit fresh sheets of paper, following the instructions
in the printer manual.
WARNING
the "Spare Parts" manual does not authorise the
user to do any work on the machine except for that
specifically described in the operator's manual,
but does enable the user to provide accurate
information to the after-sales service, in order to
reduce service times.

mAINTENANCE

WARNING
CORGHI declines all liability for claims deriving
from the use of non-original spares or acces-
sories.
WARNING
Before making any adjustments or performing
maintenance, disconnect the electrical supply
from the machine and make sure that all moving
parts are suitably immobilised.
Do not remove or modify any parts of this equipment
except in the case of service interventions.
ATTENTION
Keep the working area clean.
Never use compressed air and/or jets of water to
remove dirt or residues from the equipment.
When cleaning, take care to avoid creating and
raising dust as far as possible.
Never use solvents to clean the aligner or sen-
sors.
- Store the sensors carefully in a dry place, to avoid
loss of calibration with consequent measurement
inaccuracy.
Operator's Manual EXACT 70