Corghi EXACT 70 Manual De Uso página 77

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
sensors (fig.38). Once these operations are complete
the program automatically moves on to the screen
for the 10° or 20° steering lock.
Following the graphics on the screen:
- turn the front wheels in the direction shown to
10° or 20°;
- bring the arrow into the green measurement field;
use the zoom window which appears close to the
number 10° or 20°;
- wait for the data to be saved, confirmed by the
saving symbol;
- turn the wheels in the other direction in the same
way;
- wait for the data to be saved;
- return the wheels to the straight position.
End of procedure, the program automatically moves
on to the next step.
allows execution or abortion of the maxi-
mum steering lock procedure, selection of which is
displayed in the status bar by the
symbol. After the angles at 20° are saved, turn the
steering wheel as far as it will go and wait for the
signal that the values have been saved.
WARNING
The electronic turntables for connection to the
front sensors are required for performance of the
maximum steering angle procedure.
(9) Data summary (fig.40)
Once the steering lock procedure is complete, the
system automatically moves on to display of all
the data measured. This function can otherwise
be accessed by selecting the
the F5 key.
Vehicle's current situation. If the databank reference
values are available, the values are displayed: on
a red background if they are outside the tolerance
range, on a green background if they are inside the
range, on a dark blue background if there are no
Operator's Manual EXACT 70
reference values.
for the adjustment.
The stylised vehicle illustrates, in an accentuated
way, the half toe, camber and setback situation.
The icon is only active if saving is set in "Manual"
mode in the set-up.
(10) rear axle measurement (fig.41)
To access this function from the rest of the program
select the
Level the sensors and adjust the angles by bringing
the values within the tolerance range (numerical
data and graph bar coloured green).
The 2 rear axle measurement screens display the
rear camber angle, rear half-toe, rear total toe, thrust
angle, rear set-back and track difference values.
In the rear axle measurement screen,
switches between the two pages of values.
To access this function from the rest of the program
select the
Level the sensors and adjust the angles by bringing
icon or
the values within the tolerance range (numerical
data and graph bar coloured green).
The 2 front axle measurement screens display the
front caster, front camber, front half toe, front total
toe and front set-back angle values.
http://www.eichstaedt-elektonik.de
indicates that the angle is adjustable.
indicates that a help function is available
saves the vehicle's pre-adjustment values.
icon or the F2 key.
returns to normal display mode.
(11) Front axle measurement
(fig.23)
icon or the F1 key.
EN
77