Operating The Appliance; Turning On; Turning Off; Residual Heat Display - Gaggenau VR 230 620 Manual De Instrucciones

Operating the appliance

T urning on
O p e r a t i n g t h e a p p l i a n c e
The frame is cooler than the wire rack during operation.
Only use the surface of the wire rack for grilling.
The two grill elements can be controlled separately. This
means that you can grill foods that require different
temperatures at the same time. If required, you can
connect the two grill elements together and set the same
grill setting at the same time for both of them.
Push in the other control knob and turn it to the required
grill setting. The illuminated ring lights up white. If you do
not want to cook over the entire grill zone, switch on the
front or rear grill element only.
The illuminated ring dims from white to orange while the
appliance is heating up. An audible signal sounds when
the set temperature has been reached. The preheating
phase at grill setting 9 takes approximately 10 minutes.
Connecting the grill elements
Push in any control knob and turn it to the ª symbol. Push
in the other control knob and turn it to the required grill
setting. Both grill elements are now at this grill setting.

Turning off

Turn the control knobs to position 0. The indicator light
goes out.
9 WARNING
Risk of burns!
The appliance will remain hot for a long time even
after you switch it off. Do not touch the appliance
while the residual heat indicator is flashing.
9 WARNING
Risk of burns!
Only close the appliance cover once the appliance
has cooled down. Never turn on the appliance with
the appliance cover closed. Don't set down food on
appliance cover or use it for keeping food warm.

Residual heat display

After switching off the appliance, the illuminated ring on
the control knob slowly flashes orange until the appliance
has cooled enough for it to be safe to touch. Do not
touch the appliance while the residual heat indicator is
flashing.

Overheating protection

In the event of overheating, the appliance automatically
turns off the grill heating elements in order to protect the
countertop and cabinets. After the appliance has
sufficiently cooled down, turn it back on.

Safety shut-off

For your protection, the appliance is equipped with a
safety shut-off. Any kind of heating will be switched off
after 4 hours if the appliance controls are not used
during this time. The heating element will also remain off
after a power failure. The illuminated ring on the control
knob flashes orange and white alternately.
Turn the control knob to 0. You will now be able to start
the appliance again as usual.
Operating the appliance
en-us
11