Crank Installation - ROTOR INPOWER Serie Manual De Usuario

1.3. COMPATIBILITY
INpower cranks use a 30 mm Universal
Bottom Bracket (UBB) system that's
compatible with BB30 frames: PressFit30,
BBright, BBright Direct fit, BSA, ITA, BB86,
386 EVO, BB89 and BB92.
The necessary spacers required for
installation on whichever frame* can be
found in the product packaging.
For more information consult your ROTOR Authorized Dealer or bike dealer to ensure correct
compatibility of ROTOR INpower with your frame.
Visit our website: www.rotorbike.com
*Except for "A" spacers for 386 EVO frames (see pages 40 and 41 of the manual). Visit your ROTOR
retailer to obtain "A" spacers.
2. CRANKS INSTALLATION
When installing your ROTOR INpower for the first time, complete the following steps:
2.1./2.2. Road/MTB spacer verification (pages 40 and 41).
2.3. Uninstall your old cranks (page 42).
2.4. Left-side crank assembly installation (page 42).
2.5.
Drive-side crank assembly spacer selection (page 43).
2.6.a. Drive-side INpower crank assembly installation (page 43).
2.6.b. Existing ROTOR drive-side crank
assembly installation / Conversion into
INpower (page 44).
2.7. Preload adjustment (page 45).
2.8. Fine-tuning adjustment (page 45).
2.9. Uninstalling INpower cranks (page 45).
WARNING!
Read and understand this manual carefully
before installing your cranks. Improvements
of product specifications may occur without
any prior notification.
WARNING!
Ensure there is no interference between
the cranks and the frame or any other
component part.
Cranks installation 39