ROTOR INPOWER Serie Manual De Usuario página 51

6.2.4. The O-ring and its placement in the crank come lubricated, however with use it is advised
to lubricate them again when changing the battery. Use lubricants free of lithium or other
substances that could damage the O-ring material (OR-24x1.5 NBR).
6.2.5. Replace the cover by aligning its tab with the opened lock image. Make sure the contacts
on the battery cover enter their respective housings in the axle and avoid forcing them. Press
the cover while turning it clockwise until the tab points to the closed lock image. Once in this
position, the cover is closed and the battery replacement process is complete.
Open position
Make sure the battery cover contacts are not damaged after extracting it. This might
produce connectivity errors or a bad seal.
Verify that the O-ring is well-positioned in the battery cover.
Use only batteries in good condition; discard those that show signs of corrosion.
Do not throw the old batteries away with normal waste; batteries should
be disposed of properly according to local regulations.
Closed position
WARNING!
WARNING!
Battery 51