Rotor Inpower Training Use - ROTOR INPOWER Serie Manual De Usuario

7. ROTOR INpower TRAINING USE

After pairing ROTOR INpower, follow the configuration options for your ANT+™ device to
select the metrics you would like to display on your device.
Consult your trainer in order to evaluate which of the measured values provided by ROTOR INpower
are optimal to maximize your performance.
ROTOR INpower MEASUREMENT
ROTOR INpower starts measuring data automatically when pedaling. The following data are
sent by radio signal to the ANT+™ device.
POWER: power of the last complete pedal cycle. The power displayed on your ANT+™ device
is the measured power for the left leg multiplied by 2 by default (which corresponds to a rider
with a 50%/50% balance, which is a parameter that can be modified).
CADENCE: measured in RPM's (revolutions per minute).
Remove any ANT+ cadence sensor from your bike, it is not necessary and may cause
interference. Turn off the cadence sensor on the monitor, this will be displayed thanks to
INpower.
TORQUE EFFECTIVENESS (left
leg): used to interpret how much
negative torque is exerted by
pedaling, its value being the ratio
between the total torque delivered
and the positive torque.
PEDAL SMOOTHNESS (left leg):
used to interpret if the pedal stroke is rounder or more piston-like, its value being the ratio
between the total torque and maximum torque of each cycle.
ROTOR INpower training use
52
WARNING!