Manual Pairing; Calibration / Zeroing - ROTOR INPOWER Serie Manual De Usuario

3.2.b. MANUAL PAIRING
If there is more than one ANT+™ power sensor close to you: once INpower is active and
within two minutes of activation (INpower enters sleep mode after two minutes), manually
introduce the INpower "SENSOR ID" into the ANT+™ device.
The "SENSOR ID" can be found on the inner side of the left crank. This serial number can
also be found both under the barcode of the spindle sticker and on the first page of this
manual.
Sensor ID: 00002

4. CALIBRATION / ZEROING

The main reason to calibrate/zero your ROTOR INpower is to secure an exact power
measurement.
Calibrating the power meter compensates for any mechanical change that influences
measurement since the last calibration/zeroing. Calibrate your ROTOR INpower cranks after
assembling your bike with all its accessories, including pedals.
There's no need to calibrate your ROTOR INpower every time you use your bike. It should be
done when installing on the bike for the first time, pedals are installed or switched, or when
swapping chainrings requiring the cranks to be disassembled.
Calibration / Zeroing 47