Erasing All Tracks In Refresh Mode (Cd-Rw) - Teac CD-RW890MKII Manual Del Usuario

Ocultar thumbs Ver también para CD-RW890MKII:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Erasing in the refresh mode takes time . It is recommended to use
"ERASE DISC" when erasing all tracks .
A disc that causes an error during recording may be recovered by
erasing all tracks on the disc in the refresh mode .
1
Load a recorded CD-RW.
2
Press the ERASE button three times.
"REFRESH" appears on the display .
< Each time the ERASE button is pressed, the display changes as
follows:
ERASE #
(#: The last track number)
ERASE DISC
REFRESH
Total number of tracks and total playback time
< If only one track is recorded, "ERASE" and the last track number do
not appear . The display changes in the following order:
ERASE DISC
REFRESH
Total number of tracks and total playback time
< Press the Stop (H) button to stop erasing if you need .
< If a finalized disc is inserted, "UNFINALIZE" appears . To erase the
track(s), unfinalize the disc first .
24

Erasing All Tracks In Refresh Mode (CD-RW)

3
Press the Play (y) button to start erasing.
All tracks will be erased .
The time required appears on the display .
When the operation has been finished, the display returns to the
track/time display .
< Never turn the power off nor unplug the power cord during
erasing .
< During erasing, no buttons will work .
< This operation cannot be undone . Before erasing the tracks, make
sure that you really want to erase them .

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido