Remote Control Unit; Battery Installation - Teac CD-RW890MKII Manual Del Usuario

Main unit and Remote control unit
A POWER
Press this button to turn the unit on or off .
B Display
The total number of the tracks, the total play time of the disc, etc .
are displayed .
C Disc Tray
D OPEN/CLOSE (L)
Use this button to open and close the disc tray .
E MUSIC SKIP (.//)
Use these buttons to skip tracks .
Hold down these buttons to search for a part of a track .
F Play (y)
Use this button to start playback, recording, finalizing, unfinalizing
and erasing .
G Pause (J)
Use this button to pause playback or recording .
H Stop (H)
Use this button to stop playback or recording .
I RECORD
Use this button to enter record pause mode . During recording, use
this button to divide tracks .
J REC LEVEL
Use these buttons to adjust the analog recording level .
K PHONES
For private listening, first reduce the volume level to minimum .
Then insert the plug from your headphones into the PHONES jack,
and adjust the volume by turning the LEVEL knob .
L INPUT SELECT
Use this button to select a source to be recorded .
M AUTO/MANUAL
Use this button to select the mode of track number assignment .
N SYNC 1/ALL
Use this button for digital synchronized recording .
O FINALIZE
Use this button to finalize a CD-R/CD-RW disc .
P ERASE
Use this button to erase or unfinalize a CD-RW disc .
Q REMOTE SENSOR
When operating the remote control unit, point it towards the
REMOTE SENSOR .

Remote Control Unit

The provided remote control unit allows the unit to be operated
from a distance . When operating the remote control unit, point it
towards the REMOTE SENSOR on the front panel of the unit .
< Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there are any
obstacles between the unit and the remote control .
< The remote control may not work if the remote sensor is exposed
to direct sunlight or electric lighting . In this case, move the main
unit .
< If the remote control unit is operated near other appliances which
generate infrared rays, or if other remote control devices using
infrared rays are used near the unit, it may operate incorrectly .
Conversely, the other appliances may operate incorrectly .

Battery Installation

1
Remove the battery compartment cover .
2
Insert two "AA" (R6, SUM-3) dry batteries . Make sure that the
batteries are inserted with their positive "+" and negative"_" poles
positioned correctly .
3
Close the cover .
Battery Replacement
If the distance required between the remote control unit and main
unit decreases, the batteries are exhausted . In this case replace the
batteries with new ones .
For more information about collection of batteries, please contact
your local municipality, your waste disposal service or the point of
sale where you purchased the items .
Precautions concerning batteries
Misuse of batteries could cause them to rupture or leak leading to
fire, injury or the staining of nearby things . Please read and observe
the following precautions carefully .
< Be sure to insert the batteries with correct positive "+" and
negative "_" polarities .
< Use batteries of the same type . Never use different types of
batteries together .
< Rechargeable and non-rechargeable batteries can be used .
Refer to the precautions on their labels .
< When the remote control unit is not to be used for a long time
(more than a month), remove the batteries from the remote
control unit to prevent them from leaking . If they leak, wipe
away the liquid inside the battery compartment and replace the
batteries with new ones .
< Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire .
< Do not carry or store batteries with metal accessories . Doing so
may cause short-circuiting, leakage, breakage, etc .
9