Troubleshooting; Beware Of Condensation - Teac CD-RW890MKII Manual Del Usuario

If you experience any problems with the unit, please take a moment
to look through this chart and see if you can solve the problem
yourself before you call your dealer or a TEAC service center .
No power.
e Check the connection to the AC power source . Check and make
sure the AC source is not a switched outlet and if it is, the switch
is turned on . Make sure there is power to the AC outlet by
plugging another item such as a lamp or fan .
No sound.
e Check the connections with the amplifier and speakers .
e Adjust the volume .
Remote control does not work.
e Press the POWER button of the main unit to turn it on .
e If the batteries are dead, change the batteries .
e Use the remote control unit within the (5m) range and pointed
at the front panel .
e Clear obstacles that are between the remote control unit and
the main unit .
e If a strong light is near the unit, turn it off .
A TV operates unintentionally.
e Some TVs equipped with a wireless remote control may
operate improperly due to the unit's remote control operations .
In this case, turn off any other devices while using the unit's
remote controller .
The sound is noisy.
e The unit is too close to a T V set or similar appliances .
Relocate the unit further away from them, or turn the other
appliances off .
Will not play.
e Load a disc with the playback side facing down .
e If the disc is dirty, clean the surface of the disc .
e A blank disc has been loaded . Load a prerecorded disc .
e Depending on the disc condition, it may not be possible to
playback the disc . Try again with another disc .
Sound skips.
e Place the unit on a stable surface to avoid vibration and shock .
e If the disc is dirty, clean the surface of the disc .
e Do not use scratched, damaged or warped discs .

Troubleshooting

Recording is not possible.
e A playback-only disc or finalized disc has been loaded . Use a
recordable disc .
e The recording level is too low . Adjust the recording level .
e The remaining recording time of a CD-R is not sufficient . Use
another disc .
e If the remaining recording time of a CD-RW is not sufficient,
erase the last tracks or replace the disc .
e Synchronous recording does not start if the sound coming in is
quieter than the increment level .
The numbers and lengths of tracks differ from those of the
original tracks.
e The unit recognizes the beginning of a track by detecting the
increment level of sound . The track number may not be applied
to the silent part .
If normal operation cannot be obtained, unplug the power
cord from the outlet and plug it again.

Beware of condensation

When the unit (or a disc) is moved from a cold to a warm place,
or used after a sudden temperature change, there is the danger
of condensation; vapor in the air could condense on the internal
mechanism, making correct operation erratic or impossible .
To prevent this, or if this occurs, leave the unit for one or two
hours with the power turned on . The unit will stabilize at the
temperature of its surroundings .
Maintenance
If the surface of the unit gets dirty, wipe with a soft cloth or use
a diluted mild liquid soap . Be sure to remove any excess liquid
completely . Do not use thinner, benzine or alcohol as they may
damage the surface of the unit . Allow the surface of the unit to
dry completely before using .
25