Pc Mode - Effect Remote Parametering; Drivers And Software Installation - Ecler MOSC FX Manual De Instrucciones

6. PC MODE – REMOTE EFFECT PARAMETERING
The MOSC FX is world's first programmable effect DJ module.
The MOSC FX internal effects we previously described can be edited and reparametered on a PC program
via Universal Serial Bus: the edi:lab software.
The edi:lab software requires Windows 98SE, ME, 2000 or XP.

6.1 Drivers and Software installation

An installation CD-rom as well as a USB cable is provided with the MOSC FX module.
Before installing the hardware drivers and edi:lab software:
Switch ON the SCLAT200vs mixer.
Press the PARAMETER Control of the MOSC FX for 5 seconds. The led display shows "PC": you are in
"PC Mode".
Connect the USB cable between the MOSC FX module and your PC (Computer USB Port).
Switch ON the computer.
Hardware driver installation
When you connect for the first time the USB cable coming from the MOSC FX to your PC, the computer will
detect a new hardware device and request its driver installation. The driver is simply a "software link" between the
computer Operating System, the application software (the edi:lab in our case) and the communication port device
of the hardware.
Install the USB drivers from the installation CD-Rom provided with the MOSC FX.
Edi:lab software installation
Once you have installed the USB drivers on your PC you can start installing the edi:lab program running
"setup.exe" from the CD-ROM.
12