Important Remark; Introduction; Installation; Digital Connections - Ecler MOSC FX Manual De Instrucciones

1. IMPORTANT REMARK

In order to get the optimum operation and efficiency from your unit, it is VERY IMPORTANT - before you
plug anything - to read this manual very carefully and take seriously into account all considerations specified within
it. We strongly recommend that its maintenance be carried out by our Authorised Technical Services.
Do not expose the unit to rain or water splashes, and do not place liquid containers or incandescent
objects like candles on top of the unit. Do not obstruct the ventilation shafts with any kind of material.
Any change in the configuration of the unit must be carried out by a qualified technician. Should any
connection / disconnection task be done, always disconnect the unit from the mains supply.

2. INTRODUCTION

Congratulations! You are the owner of a genuine ECLER professional equipment. The MOSC FX has been
carefully designed in collaboration with leading dj performers and advance music producers, developed with the
highest quality components, and manufactured in-house (Barcelona-Spain) under strict quality controls.
The MOSC FX is a stereo module for the SCLAT200vs mixer that integrates a digital effects processor
remotely programmable via the edi:lab PC software.

3. INSTALLATION

The MOSC FX effects module takes up two width units of the
SCLAT200vs mixer. In order to install it, this free space must be thus
available. For instructions on module replacement, please refer to the
SCLAT200vs user manual.
When installing the MOSC FX module, the AUX bus sends of all
input channels must be changed from "POST FADER" to "PRE FADER".
Mixers that are shipped with this effects module are already configured
with all input channels AUX sends set to "PRE FADER". To change this
configuration, please refer to the SCLAT200vs user manual.
In order to use the mixer's AUX send for the effects module, you
must connect following sockets with the supplied stereo RCA cables:
Output "AUX SND" to input "FX IN" and output "FX OUT" to input "AUX
RTN".

3.1. Digital connections

- USB Port:
A USB Type B connector (4) is located on the front panel of the module. The USB Port allows you to edit
and control remotely the internal effect programs through the edi:lab software (see Install CD-Rom). The USB Port
connection procedure and edi:lab software use are described in chapter 6. PC MODE – EFFECT REMOTE
PARAMETERING.
- MIDI Out:
The DIN 5 (180º) MIDI OUT connector (3) allows you to control external devices using MIDI protocol. MIDI
is a standard protocol for communication between electronic musical instruments and computers. The MIDI
connection procedure is described in chapter 7. MIDI USAGE.
4
OUT 2 OUT 1 MUSIC MUTE
L L
AUX SND
R R
AUX RTN
REC 2 REC 1
POWER
SUPPLY
BOOTH MIX
FX IN
FX OUT
MIDI OUT