Ecler MOSC FX Manual De Instrucciones página 6

The value shown on the led display is a "Beat" fraction: "1.50" means "1 beat and a half" time value.
Low Pass Filter, High Pass Filter and Pitch Shifter are "manual" effects and are not affected by the TIME
control. Under VOCODER effect, TIME controls the carrier synthesis note.
E.g. with Delay effect: if the led display shows a "2.00" value, it means the processed signal is delayed 2
beats from original input signal. "1-2" means half beat.
Oscillated effects L.F.O. Filter, Flanger and Phaser are synchronized in beat-patterns where 1x beat-
pattern = 1x beat.
The push function of the control TIME recalls TIME "Synchronization References". You have 4 references
(4 pushes) per effect.
Ex. with Delay effect :
1st push automatically sets a REF. Delay Time of "1-4" (1/4 beat Delay)
2nd push automatically sets a REF. Delay Time of "1-2" (1/2 beat Delay)
3rd push automatically sets a REF. Delay Time of "3-4" (3/4 beat Delay)
4th push automatically sets a REF. Delay Time of "1.00" (1 beat Delay)
5th push comes back to 1st REF. value
- Rotary/Push control PARAMETER (9)
Controls one main parameter of the selected effect. The rotary control adjusts a different parameter type for
each effect: please refer to the effect description.
The push function of the control PARAMETER is a "TAP function". The "TAP function" allows to enter
manually a beat sequence in the synchronization system. You have to push 3 times to enter a beat sequence, then
the system will briefly display the Beat Per Minute value calculated from the push sequence (during 3 seconds).
- Effect mix crossfader DRY-WET (15)
The DRY-WET crossfader allows you to blend the processed signal (called WET) with the original input
signal (called DRY).
- FX LAUNCH pushbutton (16)
The FX LAUNCH button sends the signal after the DRY-WET crossfader to the main PGM output.
6