Bluetooth Device; Listening To Music Through A Registered Device - Sony CMT-SBT40D Manual De Instrucciones

Ocultar thumbs Ver también para CMT-SBT40D:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Note
 The operations described above may not be
available for certain BLUETOOTH devices. In
addition, the actual operations may differ
depending on the connected BLUETOOTH
device.
 Once a pairing operation is performed, it does
not have to be performed again. In the following
cases, however, a pairing operation must be
performed again:
 Pairing information was erased when the
BLUETOOTH device was repaired.
 You attempt to pair the system with more
than 8 BLUETOOTH devices.
This system can pair with up to 8 BLUETOOTH
devices. If you pair another BLUETOOTH
device after pairing with 8 devices was
performed, pairing information of the device
that was connected with the system first is
overwritten with that of the new device.
 Pairing registration information of this system
is erased from the connected device.
 If you initialize the system or erase the
pairing history with the system, all the
pairing information will be erased.
 The sound of this system cannot be sent to a
BLUETOOTH speaker.
 "Passkey" may be called "Passcode," "PIN code,"
"PIN number" or "Password," etc.
 You cannot make a BLUETOOTH connection with
another BLUETOOTH device while the
BLUETOOTH connection is established with one
BLUETOOTH device. Cancel the connection first,
and then connect with another device.
 The system supports only Sub Band Codec.
To cancel the pairing operation
with the BLUETOOTH device
Press BLUETOOTH MENU , BLUETOOTH 
or change the source.
Tip
 When the system has no pairing information,
the pairing operation cannot be canceled.
To cancel the connection with the

BLUETOOTH device

Press BLUETOOTH MENU  and /  to
select "DISCONNECT," then press
Tip
 You can also disconnect the BLUETOOTH
connection from the BLUETOOTH device.
22
GB
To erase the pairing registration
information
Press BLUETOOTH .
1
Press and hold FUNCTION  and   on
2
the unit at the same time until "RESET"
appears on the display window .
Note
 If you have erased the pairing information, you
cannot make a BLUETOOTH connection unless
pairing is performed again.
Listening to music through
a registered device
After step 1 on "Pairing the system with a
BLUETOOTH device and listening to music,"
operate the BLUETOOTH device to connect
with the system, then press   to start
playback.
.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido