Safety Notices; Causes And Rectification Of Faults; Disposal Of The Old Device - CASO DESIGN C1000M Instrucciones De Funcionamiento Originales

21.1 Safety notices

► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

21.2 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program
will not start.
Food is not sufficiently
defrosted, warmed up
or cooked after preset
time has elapsed.
The device functions
but the cooking
chamber lighting does
not work.
Abnormal noises can
be heard during
operation of
microwave.
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.

22 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety. If these were put in the non-recyclable waste or were
handled incorrectly, they could be detrimental to human health and the environment.
Therefore, do not put your old device into the non-recyclable waste under any
circumstances.
Attention
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Incorrectly selected time or
power level
Defective cooking chamber light.
Food is covered with aluminium
foil
The cookware contains metal
and sparks are being created
within the cooking chamber
Attention
Action
Close device door
Plug in mains plug!
Activate fuse
Re-set time and power level
Repeat process
Have Service dept repair
cooking chamber light.
Remove aluminium foil
Observe information on
cookware!
51