FINAL INSTALLATION
2.
Partially insert three blade screws (AA), along with
three fiber blade washers (BB), to attach one blade
arm (H) to a blade (I). Then, tighten each blade
screw (AA) starting with the one in the middle.
(Fig. 2) Repeat with remaining blades (I).
Hardware Used
Blade Screw
AA
Fiber Blade Washer
BB
3.
Locate motor screws (K) and lock washers (L) that
were removed in Step 5 on page 7.
Insert two motor screws (K), along with lock
washers (L), through one blade arm (H) to attach
blade arm (H) to motor. Tighten motor screws (K)
securely. (Fig. 3) Repeat with remaining blade arms
(H), making sure to completely secure each blade
arm (H) before proceeding with the next.
4. Partially loosen two motor plate screws (U) on
underside of motor and remove the other motor
plate screw (U). Align slotted holes in fitter plate
(E) with loosened motor plate screws (U) on motor
plate, allowing male plug from motor housing (D)
to come through square hole in fitter plate (E).
Twist fitter plate (E) to lock. Re-insert the motor
plate screw (U) that was removed and securely
tighten all three motor plate screws (U). (Fig. 4)
2
BB
x15
x15
3
4
motor
plate
E
12
AA
H
L
K
D
Male
Plug
U
I
H