Final Installation - Harbor Breeze E-BLHII52VPW5C4S Manual De Instrucciones

WIRING
2.
Wrap electrical tape (not included) around each
individual wire connector (CC) down to the wire as
shown in Fig. 2.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of box
from the black and blue (if applicable) connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (CC) into outlet box.
Hardware Used
CC E3 Wire Connector
3.
IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will cause a loud
humming noise from fan. To reduce the risk of fire
or electrical shock, do NOT use a full range
dimmer switch to control fan speed. (Fig. 3)

FINAL INSTALLATION

1. Locate two canopy mounting screws (M) on
underside of mounting bracket (C) and remove
canopy mounting screw (M) closest to the open end
of of the mounting bracket (C). Partially loosen the
other canopy mounting screw (M). Lift canopy (B) to
mounting bracket (C). Place rounded part of slotted
hole in canopy (B) over loosened canopy mounting
screw (M) in mounting bracket (C) and push up.
Twist canopy (B) to lock. Re-insert canopy
mounting screw (M) that was removed, and then
tighten both canopy mounting screws (M) securely.
Slide canopy cover (T) up to canopy (B), aligning
rounded part of slotted holes in canopy cover (T)
with screwheads in bottom of canopy (B). Turn
canopy cover (T) to the right (clockwise) until it
stops. (Fig. 1)
2
CC
x4
3
Dimmer
Switch
For illustrative purposes only--not
intended to cover all types of controls
1
M
11
CC
CC
CC
3
2
1
Speed
Switch
B
A A
T