Troubleshooting - Triton T4 1200BS Instrucciones De Uso

Troubleshooting

Problem
No function when ON/OFF Trigger Switch (10) is operated
Sander pulls to the side during operation
Belt sander running despite not touching the ON/OFF
Trigger Switch
GB
10
Possible cause
No power
Defective ON/OFF Trigger Switch
Off-centre sanding belt
Loose sanding belt
Lock-On Button (9) activated
Solution
Check power supply
Replace the ON/OFF Trigger at an authorised Triton service
centre
Adjust the belt Tracking Adjustment Knob (7) to align the
belt. If problem persists, refit the belt as instructed in 'Fitting
a sanding belt'
Ensure the Belt Tension Lever (15) is securely closed. If
problem persists, refit the belt as instructed in 'Fitting a
sanding belt'
To stop the machine, squeeze and release the ON/OFF
Trigger Switch