Changing Needle; To Remove And Attach The Foot Holder; Changing Presser Feet - Singer 384.18024000 Manual De Instrucciones

Changing Needle
_J) Needle clamp screw
(_) Needle clamp
[] Turn off the power switch.
Raise the needle to its highest position by turning
the handwheel counterclockwise, toward you, and
lowering the presser foot.
Loosen the needle clamp screw (_)by turning it
counterclockwise.
Remove the needle from the needle clamp (_).
[] Insert a new needle into the needle clamp(_) with
the flat side to the rear.
When inserting the needle into the needle clamp (_),
push it up as far as it goes.Tighten the needle clamp
screw _1)firmly by turning it clockwise.
[] To check for a good needle, place the fiat side of
the needle onto something fiat (needle plate, glass,
etc.).
The gap between the needle and the fiat surface
should be consistent. Never use a bent or blunt
needle.
A damaged needle can cause permanent snags
or runs in knits, fine silks and silk-like fabrics.
[]
Flat side
Lado plano_ Needle
M6plat vers Aguja aiguille
[]
[]
I/ /
To Remove and Attach the Foot Holder
Thumb screw
(_) Foot holder
(_) Presser bar
[] To remove:
Remove the thumb screw (_ by turning it
counterclockwise with a screwdriver.
[] To attach:
Match the hole in the foot holder (_) with the threaded
hole in the presser bar(_). Fit the thumb screw (_ into
the hole. Tighten the screw (_ by turning it clockwise
with screwdriver.
[] []
Changing Presser Foot
(_ Snap-on button (red button)
(_) Groove
(_) Pin
[] To remove: Raise the needle to its highest position by
turning the handwheel counterclockwise. Raise the
presser foot, and press the red button _) on the back of
the foot holder.
[] To attach: Place a selected presser foot so the pin _) on
the foot lies just under the groove (_) on the foot holder.
Lower the presser bar to lock the foot in place.
f
[]
17
[]
,I