Manual Buttonhole - Singer 384.18024000 Manual De Instrucciones

Manual Buttonhole (Option)
_) Stitch selector: D
Stitch width: 3 to 6.5
Stitch length: £_,',III_/,1 zone
(_ Needle thread tension: 2 to 6
(_ Presser foot B (option): Buttonhole foot
m _
m _
WIDTH
LENGTH
®
®
• Manual Buttonhole
* If the diameter of the button is more than 1.0"(2.5 cm), a
buttonhole must be made manually as follows:
[] Turn the handwheel toward you to raise the needle to its
highest position. Raise the presser foot lifter.
[] Set the stitch at" II" by turning the stitch selector.
* If the stitch is already on at" II" reset the machine in
accordance with the instructions on page 70.
[] Attach the buttonhole foot (B).
[] Pull the buttonhole lever downward as far as it will go.
[] Lower the needle into the garment where the buttonhole
is to start, and lower the foot.
%%
%[]
[]
i
i
[] Sew the front bartack and left row, then stop the machine
after sewing the desired total length of buttonhole.
[] Pull the buttonhole lever toward you.
%%
L
[] Sew the back bartack and right row, then stop the ma
chine at the starting point.
* To cut the opening and to reset for sewing the next
buttonhole, refer to the instructions on page 70.
[]
75