Advanced Functions - tau K580M Guía Para La Instalación

HOW TO SET THE SLOWDOWN (software version 2.03 and following ones)
1_ Place the gate in the closing limit switch position and set the dip-switch n°9 to OFF;
2_ Supply the K580M card and move the dip-switch n°9 to ON;
3_ Let the gate make a complete opening manoeuvre. During such manoeuvre, the card will
save the time needed far the opening and will not make the slowdown;
4_ Set the required slowdown through the RALL trimmer. Follow such steps and the slowdown
function will thus be correctly set up.
Clock function: a timer can be connected to the open-close pushbutton in order to keep the
gate open at certain times during the day, after which it reverts to automatic closing.
N.B. The gate remains open as long as the Op/Cl input continues to be activated.
"Open only" function: setting dip 1 and dip 4 to ON, the Op/Cl input will function solely as an
opening command and the gate will close only after the automatic closure time has elapsed.
"Gate contact open" function: setting dip 7 and dip 8 to OFF, the 2nd ch radio (terminals 18 -
19) will act as a no-voltage contact which indicates when the gate is open. This function can be
used to connect "ZONE LIGHTING" or as a gate open signal.
The radio receiver can learn up to a maximum of 30 dip-switches (TXD2, TXD4, BUG2, BUG4,
K-SLIM, K-SLIM-C, T-4, T-4C) or rolling codes (BUG2R, BUG4R, K-SLIM-RP, T-4RP) which can
be set on the two channels as required.
The first channel directly commands the control board for opening the automatic device; the
second channel commands a relay for a N.O. no-voltage output contact (terminals 18 and 19,
max. 24 Vac, 1 A).
The learning mode (dip-switch or rolling code) is determined by the first radio control device and
remains unchanged until all the codes have been cancelled.
LEARNING SYSTEM FOR RADIO CONTROL DEVICES
P1 = OPEN/CLOSE
P2 = 2nd channel
1_ press button P1 briefly to associate a radio control device with the OPEN/CLOSE function;
2_ LED DL8 turns off to indicate that the code learning mode has been activated (if no code is
entered within 10 seconds, the board exits the programming mode);
3_ press the button of the relative radio control device;
4_ LED DL8 turns on again to indicate that the code has been memorised (if this does not
happen, wait 10 seconds and start again from point 1);
5_ to memorise codes to other radio control devices, repeat the procedure from point 1 up to a
maximum of 30 transmitters;
6_ to memorise codes on the 2nd channel, repeat the procedure from point 1 using button P2
instead of P1;
7_ to exit the learning mode without memorising a code, press button P1 or P2 briefly.
N.B.: If the maximum number of radio controls is reached (30), the LED DL8 will begin to
flash rapidly for about 3 seconds but without performing memorisation.
433.92 MHz BUILT-IN RADIO RECEIVER
K580M

ADVANCED FUNCTIONS

15