tau K580M Guía Para La Instalación página 16

REMOTE PROGRAMMING BY MEANS OF T-4RP, K-SLIM-RP and BUG-R
With the new version of software V 2.xx it is possible to carry out the remote self-learning of
the new version of transmitters T-4RP, K-SLIM-RP and BUG-R, that is without pressing the
receiver's programming buttons.
It will be sufficient to have an already programmed transmitter in the receiver in order to start
the procedure of remote programming of the new transmitters, programmed by means of
TAUPROG. Follow the procedure written on the instructions of the transmitter T-4RP, K-SLIM-
RP and BUG-R.
CANCELLING CODES FROM RADIO CONTROL DEVICES
1_ keep button P1 pressed for 3 seconds in order to cancel all the associated radio control
devices;
2_ LED DL8 flashes slowly to indicate that the cancellation mode has been activated;
3_ press button P1 again for 3 seconds;
4_ LED DL8 turns off for approx. 3 seconds and then remains steady to indicate that the code
has been cancelled;
5_ repeat the procedure from point 1 using button P2 to cancel all the associated radio control
devices;
6_ to exit the learning mode without memorising a code, press button P1 or P2 briefly.
ATTENTION: TO memorise a code on a new type of remote control unit (e.g.: from dip-
switch to rolling code or vice-versa) both channels must be cancelled.
1- The automation does not start
a- Check there is 230Vac power supply with the multimeter;
b- Check that the N.C. contacts on the card really are normally closed (5 green LEDs illumi-
nated) and that the red opening command LEDs are turned off;
c- Check that the red LED DL8 is steadily illuminated;
d- Set dip 6 (phototest) to OFF;
e- Check that the fuses are intact with the multimeter.
2- The radio control has very little range
a- Check that the ground and the aerial signal connections have not been inverted;
b- Do not make joints to increase the length of the aerial wire;
c- Do not install the aerial in a low position or behind walls or pillars;
d- Check the state of the radio control batteries.
3- The gate opens the wrong way
a_ Invert the position of dip-switch No. 10 after having turned off the power to the control unit.
16
MALFUNCTIONS: POSSIBLE CAUSES AND SOLUTION
K580M