Short-Term Storage; Long-Term Storage - WAGNER Paint Crew Plus Manual Del Usario

Short-Term Storage (up to 16 hours)
Follow these steps when using latex materials only. If using materials that are oil-based, follow the Cleanup and Long-
Term Storage steps.
Shutdown
1. Perform Pressure Relief Procedure, page 7. Unplug
the sprayer.
2. Pour 1/2 cup water slowly on the top of the paint to
prevent the paint from drying.
3. Wrap the spray gun assembly in a damp cloth and place
it in a plastic bag. Seal the bag shut. Place the sprayer
in a safe place out of the sun for short-term storage.
Startup
1. Remove the gun from the plastic bag. Stir the water into
the paint.
2. Turn the PRIME/SPRAY knob to PRIME. Plug sprayer
in. Turn the switch to ON (I).
3. Turn the PRIME/SPRAY knob to SPRAY - MAXIMUM
pressure. Test the sprayer on a practice piece and
begin spraying.
Make sure you have already completed the Cleanup steps on pages 13-14.
1. Remove hopper. Pour approximately two ounces of light
household oil into the inlet valve (a).
3. Place a rag over the spray hose port, and turn the
switch ON (l). Let the unit run for five seconds. Turn
the pump OFF (O).

Long-Term Storage

(a)
15
2. Remove hose from spray hose port. Hold the outlet
valve (b) with an adjustable wrench, and remove the
hose with the other.
X2
4. Replace the hopper. Wipe entire unit, hose and gun
with a damp cloth to remove accumulated paint. Hold
the outlet valve (j)
with an adjustable
wrench, and tighten
the hose with the
other.
(b)
x2
(j)
English