Important; Cleaning The Spray Gun Components - WAGNER Paint Crew Plus Manual Del Usario

12. If hopper is empty of all cleaning solution, refill with new cleaning solution.
13. Turn the PRIME/SPRAY knob to PRIME, and turn the pump ON.
14. Let the pump circulate the cleaning solution out the return tube for 2-3 minutes. Turn the pump OFF.
15. Remove and thoroughly rinse the hopper once more.
16. Remove and clean the inlet filter (see Cleaning the Inlet Filter, page 12). Replace the filter when clean.
17. Replace the hopper for storage.
IMPORTANT: If you cleaned your pump using mineral spirits, it is necessary that you flush the pump again using warm,
soapy water to prepare it for storage. Repeat ALL Cleanup steps.

Cleaning the Spray Gun Components

1. Perform Pressure Relief Procedure, page 7. Remove
spray gun from the paint hose using adjustable wrenches.
3. Remove spray tip (a) from spray guard assembly.
5. Pour a few drops of household oil inside the gun
housing (see area indicated below by arrow).
English
Cleanup (continued)
(a)
14
2. Remove filter from spray gun (refer to Cleaning the
Spray Gun Filter, page 12).
4. Remove washer (b) and saddle seat (c) located in the
rear of the spray tip assembly. Clean all parts with a
soft-bristled brush and the appropriate cleaning solution.
6. Reassemble spray gun. Install gun filter tapered-end first,
and install spray tip (a), saddle seat (c) and washer (b).
Replace the filter housing and spray guard assembly.
(b)
(c)
(b)
(c)
(a)