Honda CBF500/A Manual Del Propietário página 109

Installation Notes:
To install the rear wheel, reverse the removal
procedure. Torque the axle nut to the
specified torque.
Axle nut torque:
93 N•m (9,5 kgf•m)
When installing the wheel insert the brake
disc carefully between the pads, taking care
not to damage them. Also take care not to
damage the ABS sensor (if present) on the
rear caliper. (CBF500A)
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the brake
drags or if the wheel does not rotate freely.
If a torque wrench was not used for
installation, see your Honda dealer as soon as
possible to verify proper assembly. Improper
assembly may lead to loss of braking
capacity.
95