Section Ii. Getting Ready To Sew; Connecting Machine To Power Supply; Before Using "Four Serger; For Your Safety - Sears Kenmore 385.16622 Manual De Instrucciones

SECTION li. GETTING READY TO SEW
Connecting Machine to Power Supply
(i_ Power supply plug
Power switch
_ Outlet
Machine socket
(_) Machine plug
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical powen
t. Turn off the power switch (_)
2. Insert the machine plug(_)into the machine socket @o
3. insert the power supply plug 1_ into the outlet ('_.
4. Turn the power switch (_) to activate the power.
Before Using Your Serger
Before using your serger for the first time, place a piece of
waste fabric under the presser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear
For Your Safety
* While in operation, always keep your eyes on the serging
are& Do not touch any moving parts, such as handwheel
or needle..
* Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended
- When attaching or removing any parts
- When cleaning the machine
* Do not place anything on the foot control, when not
sewing.
Polarized Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of an electric shock, this plug
is intended to fit in a polarized outlet only one way. if the
plug does not fit in the outlet, reverse the plug If it still does
not fit, contact a qualified electrician to install the proper
outlet, Do not modify the plug in any way,
Foot Controller Model YC-482J or TJC-150 is used with
Sewing Machine Model 385,16622XXX,
(XXX represents numbers 000 through 999),
Controlling Serging Speed
Serging speed can be varied by the foot control°
The harder you press on the foot control, the faster the
machine runs.
f
J