Section Ii. Getting Readyto Sew; Connecting Machine To Power Supply; Before Using Your Sewing Machine; For Your Safety - Sears Kenmore 385.15243 Manual De Instrucciones

SECTION II. GETTING READY TO SEW
Connecting Machine to Power Supply
_) Power supply plug
(_ Power switch
(_ Outlet
Machine socket
(_ Machine plug
(_ Sewing light
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch @.
2. Insert the machine plug@into the machine socket @.
3. Insert the power supply plug (_ into the outlet @.
4. Turn the power switch (_) to activate the power and
sewing light_.
Before Using Your Sewing Machine
Before using your sewing machine for the
waste fabric under the presser foot
with thread for a few minutes. Wipe
appear.
For Your Safety
* While in o1:
area.
take-up lever,
* Always turn off t_ ower switch and
- When attaching: _ _ing
- When cleaning .....
* Uonotplaceanythin_: : fo _ontrol, whennot
sewing.
Polarized Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of an electric shock, this plug
is intended to fit in a polarized outlet only one way. If the
plug does not fit in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper
outlet. Do not modify the plug in any way.
Foot Controller Model YC-482J or TJC-150 is used with
Sewing Machine Model 385.15243/15343.
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.