Beep Function - Metz 64 AF-1 digital Manual De Instrucciones

Flash bracketing series in the TTL flash mode
A flash bracketing series in the TTL flash
mode is only possible if the camera supports
the setting of a manual flash exposure cor-
rection on the flash unit (see camera instruc-
tion manual)! Otherwise, the shots are taken
without a correction value!
Flash bracketing in automatic flash mode A
The type of camera is not important for a
flash bracketing series in automatic flash
mode A.
11.9 Beep function (BEEP)
The beep function allows the user to receive
an acoustic signal for certain functions of the
flash unit. This allows the photographer to
concentrate fully on the subject and taking
the picture, and not have to worry about any
optical status indicators.
k
The beep function acoustically signals when
the flash is ready or when an error occurs.
180
Setting procedure
• Press the
for the selection menu to appear.
• Press the
OPTION
touch display.
O
OPTION
• Press the
MOD. LIGHT
touch display and select
BEEP
m/ft
• Press the
p
q
touch display.
O
BEEP
• Press the
display.
OFF
The setting is adopted immediately.
„ " appears in the INFO menu after activati-
ON
on of the BEEP function.
Acoustic signals after the flash unit has been
turned on:
• A short (about two seconds) uninterrupted
beep signal after turning the flash on indi-
cates that the flash unit is ready.
Set Beep signals when adjusting automatic
mode settings:
• A short beep signal as an alarm in automa-
tic mode indicates that the aperture and
ISO settings exceed the permissible light
control range. The auto aperture of the
mecablitz is then automatically adjusted to
the next permissible value.
D
button as often as it takes
OPTION
sensor button on the
sensor buttons on the
BEEP
.
BEEP
sensor button on the
On
sensor button on the touch