Before Cutting - Metabo HPT C 12FDHB Instrucciones De Seguridad Y Manual De Instrucciones

English

BEFORE CUTTING

1. Checking the saw blade lower limit position
Check that the saw blade can be lowered
49 mm to 50 mm below the table insert.
When you replace a saw blade with a new
one, adjust the lower limit position so that
the saw blade will not cut the turntable or
complete cutting cannot be done.
To adjust the lower limit position of the saw
blade, follow the procedure (1) indicated
below. (Fig. 8)
Furthermore, when changing the position
of a 6 mm depth adjustment screw that
serves as a lower limit position stopper of
the saw blade.
(1) Turn the 6 mm depth adjustment screw,
change the height where the screw head
and the hinge contacts, and adjust the
lower limit position of the saw blade. The
lower limit position is raised when the 6 mm
depth adjustment screw is turned clockwise.
NOTE:
Confi rm that the saw blade is adjusted so that it will not cut into the
turntable.
2. Oblique angle
Before the power tool is shipped from the factory, it is adjusted for 0°, right angle, left
33.9° & 45° bevel cutting angle and right 33.9° & 45° bevel cutting angle with the 6 mm set
screw, 6 mm hex. socket screw (A) and 6 mm hex. socket screw (B).
When changing the adjustment, change the height of the 6 mm set screw, 6 mm hex. socket
screw (A) or 6 mm hex. socket screw (B) by turning them. (Fig. 9-a, 9-b)
When changing the height of the 6 mm set screw, using the 3 mm hex key to turn it.
When changing the height of the 6 mm hex. socket screw, using the 5 mm hex key to turn it.
When changing the bevel angle to the right 45°, press the set button on the direction shown
in Fig. 9-b and incline the motor head to the right.
When adjusting the motor head to 0°, always return the set button to its released position.
NOTE:
To obtain right bevel angles, press the set button and tilt the saw to the
desired angle.
When obtain left or right 45° bevel cutting angle, do not need to adjust the left & right 33.9° bevel
cutting angle.
16
6 mm depth
adjustment screw
Saw blade
Fig. 8
Hinge
Turntable